- Liam's circuit will begin with Dominoes falling onto a light switch and turning a heat gun on, to heat a temperature sensor. Next it will start a timer, counting until it reaches 9 seconds, and then spinning a motor with a string glued to a car (to act like a pulley system). The car will have a 5V wire attached to it and will begin Justin's Circuit.
- Justin's circuit will begin with a 5V connection from Liam's circuit. This will spin a motor that pulls a stop block and releases a ball down a system of ramps. The ball will trigger a switch that sends power through an op amp, a relay, and into a timer. This will be connected to a binary counter. The least and most significant bits will be connected to an and gate which is then connected to a motor that will pull a paper off of the next group's circuit.
7. Group task: Video of a test run of your group RG.
Too bad you did not get to work together.
ReplyDeleteHow does the 5V wire transfer voltage from one circuit to the next and maintain secure so that the voltage stays constant.
ReplyDeleteIt doesn't necessarily have to remain constant, but it depends on the current to spin Justin's motor. And our voltage source for the transfer wire is separate from the toy car's motor.
DeleteLike Austin, I am unsure how the car with the 5V wire will be able to transfer voltage from one circuit to the next. Your explanation was a bit hard to follow, but besides that good work guys.
ReplyDeleteI explained it better in the reply under Austin's. But we decided to use a separate voltage source, to ensure this wouldn't be problematic.
Delete